Search Knowledge Base Articles

Configure Netscaler High Availability

Config licenses on the new appliance.
Connect the secondary to the same VLANs but don't configure them on the appliance.
Configure primary node to Stayprimary. Also enable Failsafe.
On primary, add the second node.
Certs will probably be missing on new node. From System > HA, force HA sync
Go to System > Diagnostics and sync ha files
Go to back to System > HA and force sync again.
Then on the second appliance, go to Traffic Mgmt > SSL > Certs and make sure the certificates are there.
Edit both and change the HA Status to ENABLED (Actively Participate in HA)
If the Node State is “Not UP” then edit “Down” Intefraces in System > Network >Interfaces, turn of “HA Monitoring” and “HA Heartbeat” in bothappliances.
Check HA status is Green on the top of the page.

StoreFront monitor shows down if "Check Backend Services" is enabled

To change Citrix Service Monitor port to https : $ServiceUrl = "https://localhost:443/StorefrontMon...
NetScaler Login Looping Back to Login Page

As a workaround you can change session timeout value to 60 in session profile Gatewa...
Smart Access Guide for NetScaler Gateway, StoreFront and XenDesktop

You can configure EPA Policies on Netscaler to check the configurations on the Client Device (ie Do...
Netscaler PVS Load Balancer > Cipher Issue

If using Vmware ESX machines be sure to use VMXNET3 NIC on PVS and target devices. Add pvs_svc (St...
Netscaler XML Load Balancer > Cipher Issue

With the Default Cipher Group configuration in Netscaler you will receive “None of the SSL ci...